Move Anchor Point | Licensed Warez for Mac n PC

Move Anchor Point

Share


Overview

With Move Anchor Point Version 2, you can quickly change the anchor point of a layer or group of layers
 without affecting any of its other properties, even if the layer has keyframes.
 Now you can move them based on the selected objects individually as well as the overall selection. 
You can also choose to base movements on the composition coordinates.

Using Move Anchor Point 2

MOVE PRESETS

At the top left of the 'Move Anchor Point' panel, you will see a grid of nine boxes. 
These are the 'Move Presets.’ Each button corresponds to a point where the anchor point can be moved.
 Movements are different depending on what mode is active. ('Modes' are explained in the next section).

MODES

Move Anchor Point 2 has three different modes that affect how anchor points are moved. 
The choices are 'Object,’ 'Selection,' and 'Composition'
 (found on the menu at the top right of the 'Move Anchor Point' panel).

OBJECT

In this mode, all layers in your selection are calculated individually.
 If you have 10 layers selected and you select the top left 'Move Preset,’
each layer's anchor point will be moved to its own top-left corner.

SELECTION

In this mode, all the layers in your selection are combined 
and any movements will be made on the average of all the layers combined.

COMPOSITION

In this mode, the movements are all based on the composition size 
and are not affected by your selection or any of the layer properties.

INCLUDE / IGNORE MASKS

This option allows you to choose whether or not masks have an impact on where anchor points are moved. 
If you include masks, anchor point moves will be calculated after masks. 
If you ignore masks, the calculations will happen before masks are applied.

CUSTOM MOVE

This area allows you to enter specific values for how anchor points are moved. 
The selected mode does apply to 'Custom Moves.’ 
The three text boxes correspond to the X, Y, and Z axes. 
Following these three boxes are two choices for value types. 
You can either choose 'px' to move anchor points to a certain pixel position, or '%' to 
move anchor points based on percent values. 
All values are relative to the upper left corner of the ‘Object,’ ‘Selection,’ or ‘Composition’ 
depending on which mode is active.
To do a custom move, simply enter your desired values, choose the value type and click 'Custom Move.’ 
You can enter numeric values as well as fractions and simple math if needed.

MATCH

This button allows you to match a layer's anchor point or group of layers to any other layer. 
To use this, select all the layers you would like to affect,
 then select the layer you would like to match to. Then click the 'Match' button.

Download  HERE

0 comments:

Post a Comment